The Short Answer
- My take: the real cost of the gas rule is the electrical work a heat pump can set off, not the appliance.
- Most homes won't need a bigger panel, but find out before something breaks. An electrician's evaluation now beats a surprise in an emergency.
- Sellers: get the electrical picture before you list, and don't convert just to sell. Buyers: add an electrician to your inspections and budget for a heat pump, not a simple swap.
Say it's a February morning in 2028, and the gas water heater in your Sunnyvale garage quits. You figure it's a simple swap. Then the plumber says a new gas unit isn't allowed without an exemption, and a heat pump needs its own 240-volt circuit, a heavy-duty line like an electric dryer's. The electrician opens your panel. It's original to the house, and it's full.
Now you're not shopping for a water heater. You're asking whether your house has enough power. I don't think most homeowners have heard about this part of the "gas ban."
The rule, briefly
From January 2028, the Bay Area Air District requires a replacement water heater in a house or smaller building to be zero-emission, usually an electric heat pump. Condos in buildings of five or more units can get an exemption until 2033. Furnaces follow in 2029, condos included. Working gas equipment can stay.
Homes with electrical limits, like a very small or maxed-out panel, can get a one-time exemption from the water heater rule if a contractor documents it. There's also an income-based exemption, including for owners whose mortgage and property taxes take 28% or more of their income. The furnace rule has no exemptions yet. An Air District official said during drafting that the electrical exemption buys you the replacement gas heater's lifetime to fix the wiring. I'd call that a snooze button, not a fix.
The can of worms: a chain, not a swap
For a standard heat pump, that line can start a chain:
- The circuit. No heavy-duty line nearby means running one, which needs an empty panel slot.
- The panel. About a third of California single-family homes have 100-amp panels (amps measure how much electricity a panel handles at once), a smaller size common in houses built before the mid-1980s. A full, undersized or unsafe panel may need replacing.
- The utility. A bigger panel can mean your utility (PG&E, or a city-run one like Palo Alto's) has to upgrade the line to your house, sometimes digging a trench. A 2022 PG&E-commissioned study put those upgrades at about $2,000 to $30,000 or more in total, and they can take months.
- The permit. An inspector who opens your panel can flag more: grounding (its protective connection to the earth) brought up to code, required smoke and carbon monoxide alarms, old wiring, past unpermitted work.
As I see it, the appliance is the easy part; the wiring is the real cost and timing risk. Most water heaters get replaced in an emergency, the worst time to learn your panel is full.
To be fair, most homes won't hit the worst of it. A Silicon Valley Clean Energy study of single-family homes found 90% could add two heat pumps even on one of those smaller panels, without an upgrade. Workarounds help: plug-in models that run on a regular outlet (they reheat more slowly) and devices that let two appliances share a circuit. Ask a licensed electrician and your building department what fits.
Planning to sell? Get the electrical picture first
Since Jan. 1, 2026, most California home sellers must give buyers a notice saying an electrical inspection may be advisable. It flags faulty wiring as a fire and insurance risk, and limited capacity as a barrier to solar, EV charging or electric heat. Sellers of single-family homes must also disclose known gas-appliance rules like this one.
My take: that notice invites the buyer to open your panel, so open it first. Before you list, have an electrician check the panel and pull your permit history from the city or county. That's how you find a Federal Pacific or Zinsco panel (brands some insurers may not cover), older knob-and-tube or aluminum wiring, or unpermitted work before the buyer's inspector does. Then decide whether to fix it or price it in, and ask a real estate attorney what to disclose.
Don't rush a conversion just to list. The rule doesn't require it, and a panel permit mid-listing can raise questions you'd rather answer on your own time.
Buying? Look past the water heater
A general home inspection usually doesn't judge whether the panel can take new electric equipment, so add an electrician's evaluation, compare permit records with the house, and look at:
- The panel: size, brand, age and empty slots for new breakers.
- The water heater spot: a heavy-duty line and enough room nearby; a cramped closet can rule out a heat pump.
- The furnace: central air, whose circuit can often serve a heat pump.
- The exemption: whether a past owner already used the one-time electrical exemption. It stays with the address.
If the water heater or furnace is aging, budget for a heat pump plus the electrical work, not a simple swap. In our experience, an old water heater next to a small, full panel is fair to raise when asking for a repair credit, especially with an electrician's estimate. Our buying plan shows how we build that into an offer.
Back to that February morning
Now say you'd had the panel checked in 2026. You'd know whether a heat pump or a plug-in fits, or you'd have done the electrical work while nothing was broken. The plumber shows up, and it's a swap again.
The rule doesn't force anything out of your house. It changes what the next replacement involves, so find out on your schedule, not the water heater's.
Curious how your panel affects your home's value? Start with a free home value report or our listing plan, in San Jose, Sunnyvale, Mountain View or anywhere in the Bay Area.
Questions, Answered
Do I have to replace my gas stove or a working water heater?
No. The Bay Area rule applies only when you replace a water heater (from January 2028 in houses and smaller buildings; condos in buildings of five or more units can get an exemption until 2033) or a furnace (from 2029). Working equipment can stay, and you can keep repairing it. Gas stoves, dryers and fireplaces aren't part of it.
Will I need a new electrical panel for a heat pump?
Often not. Silicon Valley Clean Energy studied more than 115,000 single-family homes and found 90% could add two heat pumps even on a 100-amp panel, without a panel or service upgrade. Plug-in heat pump water heaters that run on a regular outlet can often avoid new wiring, where your building department allows it. Older homes with small, full or outdated panels are the ones to check. A licensed electrician can work out how much power your home needs at its busiest.
Do sellers have to get an electrical inspection?
No. Since Jan. 1, 2026, most California home sellers must give buyers a notice saying an electrical inspection may be advisable. It doesn't require an inspection or any repairs. Separately, the standard seller disclosure form asks about known electrical problems and work done without permits. This is general information; your agent or a real estate attorney can tell you what your disclosures need to say.
What if my panel can't handle a heat pump when my water heater fails?
The water heater rule has a one-time exemption for homes with certain electrical limits, such as a panel under 100 amps, a panel with no room for another breaker, or a water heater spot that would need more than 50 feet of new wiring, and a licensed contractor has to certify it. It also allows a temporary installation in an emergency. The Air District hasn't announced when its exemption process opens. The exemption is good for one replacement per address, not per owner, so a buyer can't use it if a past owner already did. I'd treat it as time to plan the electrical work, not a way around it. A licensed electrician or contractor can tell you what applies to your home.
Sources
- Rules 9-4 and 9-6 Building Appliances (opens in a new tab), Bay Area Air District, 2026-11-05
- Regulation 9, Rule 6 amendments, adopted regulatory language (sec. 9-6-111 income and housing-cost exemption, 9-6-112.3 electrical exemption, 9-6-113.2 multifamily delay) (opens in a new tab), Bay Area Air District, 2026-10-30
- Board of Directors presentation, Nov 4, 2026 (water heater rule amendments) (opens in a new tab), Bay Area Air District, 2026-11-04
- Water heater rule overview flyer (exemptions available once per address) (opens in a new tab), Bay Area Air District, 2026-11
- Air District Board of Directors Adopts Water Heater Rule Amendments, Delays Implementation to January 2028 (Air District release) (opens in a new tab), Bay Area Air Quality Management District Communications, via Contra Costa Herald, 2026-11-05
- Bay Area Air District Votes to Delay Zero-Emission Water Heater Rule (opens in a new tab), KQED, 2026-11-04
- New deadline for phaseout of gas water heaters gives Bay Area homeowners one more year (opens in a new tab), CalMatters, 2026-11-05
- Bay Area looks to exempt some households from gas water-heater phaseout (opens in a new tab), Canary Media, 2026-05-20
- Heat Pump Water Heater Installation Guide (opens in a new tab), ENERGY STAR (U.S. EPA/DOE), 2024-08
- How to electrify on a 100 Amp panel; What circuits and outlets you'll need (opens in a new tab), Rewiring America, accessed 2026-11-10
- Electrical Service Panel Capacity in California Households with Insights for Equitable Building Electrification (opens in a new tab), Lawrence Berkeley National Laboratory / UCLA (ACEEE Summer Study), 2024
- Design Guidelines for Home Electrification: Decarbonize without upgrading electrical service capacity (opens in a new tab), Peninsula Clean Energy (now WestLight Energy), hosted by TECH Clean California, 2023-02
- A roadmap to your electrical panel upgrade (CRS-0825-5760) (opens in a new tab), PG&E, 2025-08
- Residential project resources (opens in a new tab), PG&E, accessed 2026-11-10
- Service Upgrades for Electrification Retrofits Study Final Report (CALMAC PG&E0467.01) (opens in a new tab), NV5 and Redwood Energy for PG&E, 2022-05-27
- Solving the Panel Puzzle (opens in a new tab), SPUR, 2024-05
- Residential Electrical Panel Replacement (opens in a new tab), City of East Palo Alto Building Services, 2022 CEC edition (accessed 2026-11-10)
- Self-Certification for Smoke Detectors & Carbon Monoxide Alarms (opens in a new tab), City of Palo Alto Planning & Development Services, 2024-06-24
- Smoothing the Transition to Heat Pumps, Part 2: Permitting and Inspections (opens in a new tab), SPUR, 2024-10-21
- Retrofit Market Decarbonization with Plug-In HPWHs: California-wide Field Study Results (opens in a new tab), TRC Companies / New Buildings Institute via ACEEE, 2024
- Electrification – Sorting Facts from Fiction (opens in a new tab), Silicon Valley Clean Energy, 2025-11-20
- How to Electrify Your Home Without Upsizing Your Electrical Panel (opens in a new tab), City of Palo Alto Utilities, accessed 2026-11-10
- California Civil Code section 1102.6i (electrical system notice) (opens in a new tab), california.public.law (statute text), operative 2026-01-01; verified 2026-11-10
- California Civil Code section 1102.6j (gas appliance replacement disclosure) (opens in a new tab), california.public.law (statute text), operative 2026-01-01; verified 2026-11-10
- Civil Code §1102.6: Mandatory Real Estate Transfer Disclosure Statement (opens in a new tab), Epsten APC (law firm), 2014-01-30
- SB 382 (Becker) Senate Judiciary Committee analysis (opens in a new tab), California Senate Judiciary Committee, 2024-01-11
- Knob-and-Tube Wiring (opens in a new tab), InterNACHI, accessed 2026-11-10
- Repairing Aluminum Wiring (Publication 516) (opens in a new tab), U.S. Consumer Product Safety Commission, 2011-06
- InterNACHI Home Inspection Standards of Practice (opens in a new tab), InterNACHI, accessed 2026-11-10









